Search:

Abit late but did you try rimmerbros? https://rimmerbros.com/Item--i-GRID001438

I had less headache with the MG to be honest john, kids loved it and she moved when she needed to unlike this st where it struggles just moving 4 people in it.

Well done bud, yes i'm still around as once i move i'm getting a zr again :) hate the headache the mk2 st is giving me.

Shes looking nice, you got a lot of work to do by the look of it.

If you take out the glove box you will see a black box, this it your bcu, people charge 5-10$ to replace one resistor, if your lucky you could get all done for 10$

Have you checked if your resistor in your bcu is ok? had this on mine and had to replace it.

Late reply but dam that was close.

Looking nice there john, a nice honda engine swap is what i was going to do with the ZR but could never find one myself, the week the car went i ended up finding one lol

Great engines and way less...

If its the crank sensor i would be surprised and it would not have started, have you checked the timing if your thinking its that?

you could of renewed it yesterday but it will not stop a sensor...

I would check cat and pre cat sensors make sure no brakes in the wire, how old are they? might be due to a change.

Have you checked all wires from ECU? the zr is a pain and even with faults on my...

The problem with zr/25 is water by the ecu, always been a problem, back box does hold water, if you are leaving the car for so long best advice is bag over the end or cork it, saved me buying a new...

Check the wiring, i had this problem and found it was a wire on the ecu side.

Make sure they are tight so no air is getting in or out as they need to be super tight, clean the contacts including...

You can but i doubt you'll get any buyers, place is dead and other sites are just about getting people posting.

Have you checked all rear end? engine supports? (including the one under the engine) john would be best for this thing but due to RL his not on as much.

my car went in for a early MOT and it had a small over heat but never went 3/4 of the way as fan cooled it down, since then my car has started holding air and i found my top hose of the engine to...

Hi and welcome

Nice mileage and its best to put it through the MOT before anything, see if you can get a HGF check and compression check (this really is to make sure you engine is fine)

Get a...

Looks nice but i'm sorry to say, the site is dead so the member might have moved to a better low problem car.

I own a 04 plate 1.4L have no problem with the electronics the only one would be the boot loom which is a 5 minute fix.

The head gaskets are fine if you drive properly and not try and rang the car...

You will need to put the same gearbox in but if i'm right you will need some work doing to change it to a manual gearbox as the linkage needs changing and i'm not sure the bcu needs changing to a...

Thanks for replying john, we heard the noise real bad when we was waiting on the back window seal to cure, the cover was rubbing but when we moved it the bigger noise was still there but seems top...

If its never had a change of oil (gearbox) and its due i would check the state of it for sure, when i replaced my engine my oil was black like tar and that was at 67k i would be careful as well as if...

Is there any juttering? have you had it plugged in before buying the car (its a must on inspecting a MG) John will help a ton if he sees your post but its kinda dead here.

Hi

Would anyone know what oil a 05 rover 25 takes, replaced my engine last year with a 36k engine from a 25 but i'm thinking its not the same oil as my zr was 10/40 as its like its not lubing and...

Boddney if you take the air box off (by the battery) you will see the gearbox, there should be a white label that tells you what you need including the ratio. after you know what box you have just...

That is good to hear buddy, when you said ages i was thinking a few years like most rover/mg owners do then sell the car.